💡 Aiposen 110V/220V AC to DC 24V 2A 48W Switch Power Supply Driver - Optimized for CCTV Camera, Security System, LED Strip Light, Radio, Computer Project (24V 2A) Review

I have a very small load (less than 2m RGB LED strip), but it is small, light and passively cooled, so you can take pictures comfortably there, where you are is needed under a table or in something for example.

Tested this device. I needed 25.5 volts so I easily adjusted the potentiometer to 25.5 volts and then added a load to get the 2 amp output current. He handled it well and didn't get too hot. Perfect!

Good, stable performance, good workmanship. I haven't drawn much power with it yet, so if it's not up to date I'll do another check. The 24v motor I tested drew only one amp, so I don't expect any problems with this power supply.

I service tools that usually cost around a million dollars. A power supply failure would have cost the manufacturer $1,500. It works great, we've been using it for a long time.

I would like the seller (manufacturer) to attach the circuit board and circuit diagram (including components) to these devices. Just in case (over time if the IT breaks down or fails) I can get it back to a working state after determining what failed/burned down. This is valuable information (even if I'm the one who broke it).

I needed an AC transformer and didn't realize it until I installed this. It works great but I burned some of the hardware before figuring it out. Don't make the same mistake I did. I like the regulated voltage (it was set at 24V and I had to reduce it to 20V) because long cable lengths sometimes have a large voltage drop. Of course you need a multitester for your project.

It does exactly what it advertises. Performance configurations, not just one. This review is about the one that converts AC to 24 volts DC. It makes no noise when it's working, and there's no fan either. I believe the comments mentioning noise and fans are from people who have bought higher wattage PSUs. This supplies 24VDC, 2A, 50W. (Note: the product description says 48W, but the unit I received is labeled 50W.) No fans, no noise, just power conversion and not a single sound. I'll also add…