Amarite Cabinet Corner 1320Lbs Capacity Review

We bought these to use on some of our heavy furniture like our baby grand piano and our large antique bookcase. The wheels glide very smoothly and support the weight of these heavy objects. There are soft pads on each mover so you don't have to worry about them scratching the items you are moving. It is great! Highly recommended.

I ordered these to carry a gun safe that weighs about 550 pounds. It maintains a low weight relative to the ground, which is useful when pushing and moving. However, there are two problems: The low ground clearance makes it difficult to negotiate doorsteps or drive up and down a ramp. Second, because they are not related. on the other hand, they can slide around. I solved this problem by putting a ratchet strap around the base so they fit snugly in the bottom of the safe.

I liked the product - I bought it to bring a specific heavy item to my house which was delivered. It turned out that the wheels are so small and the height of the floor is so low that the object cannot roll over my threshold even with a small ramp. At the height of the project I had to run to Home Depot and buy an alternative. The product seemed suitable to me when I was rolling on a very flat surface, i.e. moving objects around the house. But for the application I bought it for, it was…

An intelligent system for moving heavy loads. The corners of the cabinets are mounted in a low bracket that is about ½ inch off the floor. That means you don't have to lift that heavy weight very far to load and move it. It looks like a power coating or at least thickly colored. The mount has a 2 inch diameter rubber pad that prevents your items from moving or sliding off the system. Easy to roll even under heavy loads. What can I say. They accomplish the task for which they were designed with…

Looks great, but there's a problem. Look at the photos, the ruler is aligned with the axes on the rollers. Pay attention to the position of the rubber seal. Placing a weight in the center of the pillow will flip the whole assembly over, like in the third picture. I moved a lathe with 3" round feet and it did the same thing as in the third picture. Moving something with short legs an inch from the edge doesn't work. Another design flaw, no matter where you place the machine's legs in the drive…