Enhance Your License Plate Mounting with the Bell Automotive 22-1-46230-8 Adjustable License Plate Frame Bracket Review

I didn't want to drill out the bumper, but I got a repair ticket. This allowed me to temporarily install it on the grill. I replaced the included screws with a butterfly kit and washers. He stayed in place very well. This can be a permanent installation if required. Very stable. The only thing I would add is to stick some felt on the back of the license plate for any areas that might touch/scratch the bumper. I had light scratches on my bumper from not doing this. Individual or special sets…

I bought this to install a faceplate on my 330Ci as it was not included and I received a repair ticket. I used some butterfly screw wall anchors to install it without removing the bumper and all worked fine. The bracket didn't quite fit the part of the bumper above it so the plate was rubbing against my bumper, I needed tape or something to keep it from scratching. I understand it's not the repair's fault, but the problem is that after a week on the car the bolts started to rust. It's cheap…

It's easy to install, easy to adjust, durable, affordable and comes with almost everything you need. You may need to purchase some washers/nuts and additional plate screws to get the plate to fit. In my experience it would be very easy to mount it on a bumper with pre-drilled holes. I used it on my 2013 C350 which has a sharp edged front bumper making it difficult to fit the plate properly. I didn't want to drill holes in my bumper so I decided to attach the bracket to my mesh grille and then…

Fits my 2009 Honda Odyssey perfectly. I bought a used Honda Odyssey from a state that didn't have front license plates, so I didn't have the front license plate bracket that my state requires. I bought a factory Honda license plate bracket and it was really flexible and I had to drill a hole and put a screw in the bumper to install it so it wasn't flexible. I didn't want to do it. This Bell mount was a solution that worked great. I had to buy wide washers, nuts and longer bolts to reach and…