🖨️ Creality Enhanced 3D Platform: 235x235x3mm Review

Here's a quick rundown: ProsHere's what makes a glass surface a must-buy:* Inexpensive* Well packaged* Looks great* Includes texture to help the filament stick to the building surface* Includes this Creality logo on the surface looks like a standard * easy to install * easy to level * no visible deformation after a few prints * VERY easy to remove the print once the surface has cooled to about 45 ° it was a double minus ?): * others might think it's a bit pricey as you can get a piece of glass…

Good. So many reviews and broad mixed feelings about these glass beds. In any case, since this was my first 3D printer and my first exposure to this genre, I had a completely open mind, so this review will reflect the pros and cons. First, the bed is good. No defects, very well packaged to avoid damage in transit, worth the money. I didn't straighten it to check for warpage, but I had absolutely no alignment issues. Next, let's talk about the only real problem I have. It's not enough to ring…

Mine had a small chip but it's not big enough to cause a problem and it's in the bottom plate. Surprisingly smooth underside for prints * No warping or other problems with the initial layer * Removal is often easier than with a magnetic board (although prints sometimes stick a little) * Perfectly flat printing surface! (much easier to align than a magnetic build plate) CONS * Adhesion isn't very good * Using medium clamps means you lose little build area (not much) * It takes longer to heat up…