🚗 Aishun Dtouch Universal Black Side Skirts - 450mm Exterior Side Bottom Line Extensions Splitter Lip Car Diffusers Review

These are perfect for my custom finish. They're a bit on the flimsy side. Hollow on the floors. But they work for me. Thanks very much!

I put this on my 2008 g37 and from a distance it looks official. Its end curves a bit depending on where you put the screws, I think it's because of how thin it is. So be careful where you place the screws.

That sucks. The outside is folded because they are hollow. They are hydrocoated carbon fiber, I ordered black. It wouldn't matter if they weren't actually carbon fiber. (Given the price) I will not install. throw them away

One of the aprons arrived uneven and looks wavy. The other was perfect. Otherwise looks great. I wish I could have had a better look at it before installing it. I can't return the meaning, I put it on and colored it red. 😭😭😭😭 I will order more but from a different seller. They are red.😆😆

I bought these primarily to help hold my standard side skirts together and they do a very good job. They make my e30 more aggressive. But these are cheap little plastic parts that are very structural. So you definitely get what you pay for. But if you're on a budget then put these bad guys on your plain or neon and be more aerodynamic.

Not sure how the crack started. I know I didn't hit anything. Ease of installation. The price is ok for what it is. I think it could be a bit cheaper. Doesn't seem very strong and brittle after a while. I got them in just 3-4 months. And I purposely did NOT go to car washes to see if they would help with normal driving. You can see the photos yourself. I would buy it again only if the price was lower.

Not too shabby. Adds that aerodynamic look without a big expense. It sure looks cheap and being plastic it can flex a bit when you take it out. If you're looking for a quick, cheap supplement, get this one. If you want functionality and quality, go elsewhere. I just put 3m car tape on it and stopped because it's so light. Let's see how it holds up

I knew this wasn't going to be a top quality product but after unboxing it straight away I was disappointed. For the injection molded part, the manufacturer didn't even bother to fill or support the fin to prevent it from bending like mine did (photo included). Now I understand why there are no photos of the bottom - this product is thin all over. For the price And you need to drill your own pilot holes. I'd rather try my hand at thermoplastic molding for the first time than bother with it.