🔌 High-Quality Electric Fuel Pump 12v for Kawasaki Mule Vehicles - 49040-1055 KAF620 Compatible with Models 3000, 3010, 3020, 2520, 2500, 2510, 1000 - 8mm In/Outlet Review

Worked great for two months and then just stopped. The installation is not difficult, but it clicks loudly. This morning it just stopped and there is a clicking noise and fuel flows to the carburetor. Should have bought the OEM version. Now I'm stuck without my mule, which I use around the yard several times a week.

I think I'm a diligent student! Bought two of these Chinese fakes. Bought one from Revain and one elsewhere. Both failed after a short time. This is absolute rubbish. I burned myself so many times from buying Chinese crap! Only recently I finally ordered and received an original Kawasaki OEM made in Japan. The cost was significantly higher ($200.00). Works better than any Chinese junk straight out of the box. I THINK I'M STILL LEARNING ABOUT CHINESE FUCKING CHARACTER!

So far, so good. There is such a thing as "frighteningly cheap". I would say that this fuel pump is in that category. It seems to make more noise than the original and is a bit cheaply made, but if I can use it for another 2-3 years I would consider it a worthwhile purchase. In addition, it can be replaced quite easily and quickly. I would say the total changeover time on my Kawasaki Mule is about 15 minutes. Considering the cost of the original pump, I think it's definitely worth a try! I'll…

Updated to say it still works great. Inside the box was a card that said I would refund Revain $1 for writing a review for the company. I did NOT receive that $1, so don't count on it. However, I have written this review honestly. The electrical wires and breather hose are not in the same location as the original Kawasaki (actually opposite locations on the cap) and the fuel inlet/outlet was slightly larger than the original. but everything went well. The hardest part was removing the old one…

Update: Seller contacted, very responsive, replacement should arrive today. Upgrade from 1 to 3 stars pending installation and rating of the new device. Original: Installed in 2000. Mule 2510. Everything seemed to work fine but sometimes I found a strong smell of petrol. Eventually it turned out that the pressure-controlled cut-off of this pump did not always work, that is, when the carburetor float rises, the back pressure must prevent the fuel pump from continuing to pump fuel into the…

I'm not a mechanic but I had no problem installing this replacement part when my factory fuel pump started leaking. The electrical connection was a bit risky, since it was not clear from the factory which (+) wire is positive and which (-). I made an educated guess and it worked. The only negative feedback is that the replacement fuel filter is not the right size for the factory installed gas line from the fuel tank. It would be nice to change the filter but my real goal was to replace a…