Enhanced Dimensional Accuracy ESUN Printer Filament for Additive Manufacturing Solutions Review

The filament is really nice and shines beautifully in the light when the prints really come out and not just fall off. However, I had serious problems with layer to layer adhesion and if I can get the layers to stick they will shrink everywhere due to too much heat. Other times it prints just fine with the exact same settings it was printing horribly at just hours before. It makes no sense. This doesn't happen with other threads I've used and I'm starting to think it's just this branded or silk

I ordered this hoping to print some things with bright, ever changing colors. Imagine my surprise when the first things I printed were mostly gold with no visible color changes. Hm. Now I've printed a lot of things and now I see the color change. Sometimes the gold is greener, sometimes yellow, sometimes orange. But we don't see bright reds, yellows, greens, or purples. This is apparently not the same rainbow. It doesn't matter that "rainbow" means a specific color sequence. The filament is…

I've had bad experiences with eSun Silk Silver 1.75mm. When I first received it I printed this swirled piece in vase mode and it looked great (see below). I searched the eSun website for more information and found the following: Best Printing Temperature: 190-20℃ Base Temperature: No Heat / (60-80)℃ No Heat? For real? Ok I'll try. I use Magigoo for most of my prints so I left it on my bed and didn't heat it up. My first print curled a little, but not much. The print job stopped after a few…