🚀 High-performance FormFutura ApolloX ASA 1: A Durable and Efficient 3D Printing Filament Review

This is by far the most amazing filament I have ever tried. every layer, every line, every top and bottom. Everything is perfect. If your computer is running at peak performance I would recommend trying this thread. I'd say if you run into problems check your slicer and/or machine as it's not threading. This material prints like oil. In the 3 years I've been typing I've never seen filament lay down so incredibly perfectly. Seriously, get it and you won't regret it. Apollo x black for victory.

Grade A filament. Print quality is excellent. Printouts are clean even when using the standard ABS profile. I'm sure that a little tweaking will make them nearly flawless. Adhesion to the PEI film is excellent. In fact, it's almost too good, and some of my prints had slight discoloration on the underside due to the stress of peeling off the print surface. The flexible spring steel sheet definitely helps with removal. Because it is chemically similar to ABS, virtually all of the same…

Print Voron parts with this filament on Ender 3, with MicroSwiss all-metal hotend, with and without housing. It prints very cleanly but is slightly cooler than recommended (230°C at nozzle, 90°C at table - 61°F/16°C ambient at 61% humidity). The prints look great. However, be very careful when downloading this thread. The winds on the barrel are terrible and the barrel spins very quickly even when the tension eases off a bit. I had to unwind about 6 feet of thread and rewind it tightly to keep…