🔧 Upgraded Silver Offset Intake Manifold and Gasket for 49cc 66cc 80cc Motorized Bikes - Enhancing Motorised Bicycle Performance Review

I used it as an exhaust manifold for the Preditor 212. I have worked with modifications but there are others that are more suitable. Came super fast.

JRL and I have done a great job but this may be the last. What kind of. I mean what happened to this thing? The bag it came in looked like it had been used, reused, then reused to send me someone else's junk.

Didn't fit, touched the clutch and couldn't use the other side (I think it's just a problem with my setup) Then the welds really suck and in general there is a stain from welding that can dangerously get into the engine would not buy one like this

Perfect fit. Welds inside and outside clean. The paint is thick and cured well, although I had to sand it down a bit where the carburetor goes because the fit was so tight. The gasket appears to be of good quality and the enlarged screw holes make installation easier.

This is exactly what I needed. Although I had to tighten the right side with a needle vise because the Allen key didn't fit. Although everything is fine. 🌟🌟🌟🌟🌟 And one more thing. You will need three spacers as the one that comes with the offset intake manifold is too thin.