Enhanced KODAK ABS Filament 2 for Additive Manufacturing Solutions Review

Good yarn at an affordable price. I've ordered it twice and both batches have good adhesion, durability and print quality. While this is a good thread, I don't recommend it. The spools are too small for this amount of filament, they are completely full, so they unroll themselves and get tangled around the spool holder. Most other brands have larger spools and fill the spool to about 1/2 inch from the brim. Also, these smaller spools are very thin so they may not work with some spool holders…

I bought this because my regular ESun and Hatchbox were sold out and the Kodak red was almost the same shade. Although wow the Kodak ABS print quality is amazing and even better than the hatchbox which is very good. That being said, ABS is a very difficult filament to print and requires a fully enclosed printer with a preheated chamber. My prints were done on a Voron 2.1 at 240°C through an E3D Volcano with a 105°C bed and on PEX and PEI spring steel sheets at 120mm/sec. With these settings the

I would like to rate 4.5* This gives excellent print quality right out of the box and couldn't be better in the packaging. It is in a vacuum zip bag with aluminum processing (moisture resistant) and in a protective film in the box. It's hard to get better and it's dry. I open the package, skip the drawing step, upload it and run it with the same setup I use for all ABS threads (Raise3D mostly). It has a very good finish and dried but ready to use. I notice more tension than usual when loading…