📸 KODAK 2mm ABS Filament Review

I bought this filament because my regular ESun and Hatchbox were sold out and the Kodak red was almost the same shade. Although wow the Kodak ABS print quality is amazing and even better than the hatchbox which is very good. That being said, ABS is a very difficult filament to print and requires a fully enclosed printer with a preheated chamber. My prints were done on a Voron 2.1 at 240°C through an E3D Volcano with a 105°C bed and on PEX and PEI spring steel sheets at 120mm/sec. With these…

I wish I could give it a 4.5 * This gives excellent print quality out of the box and couldn't be better in the box. It is in a vacuum zip bag with aluminum processing (moisture resistant) and in a protective film in the box. It's hard to get better and it's dry. I open the package, skip the drawing step, upload it and run it with the same setup I use for all ABS threads (Raise3D mostly). It has a very good finish and dried but ready to use. I notice more tension than usual when loading (not…

See our original review below. The color results we tested with this ABS were top notch. However, when we safety tested the products we made with this thread, all products made with a yellow dye (yellow, orange, and green) tested positive for unacceptable levels of lead. Colours. However, we can no longer recommend their threads in good conscience. We only tested these plastics for lead. We have no idea what other harmful substances might be in this product unless they are properly tested for…