Leveling KSP 2004 2016 Spacers Warranty Review

Essential when you need to remove the rake from your truck. This is an installation job that requires some mechanical skill as well as adequate installation tools. I've installed several alignment kits over the years and it wasn't easy with the first page. Be sure to rotate the assembly when reassembling, and also have a good pry bar handy. Also loosen the lower A-arm bolts as I have found that the extra movement makes installation much easier. I'd say it would be easier with a different pair…

Kit does what it says, raises the truck 3 inches in the front. The hardest part of the installation was the parts on the truck. Before installation the two spacers looked exactly the same and one fit like a charm but no hole was drilled on the other side as the spacer moved to one side when tightened to the truck frame and the nut could not fully fasten to the frame . spacer A gasket isn't that good if it has a manufacturing defect. Customer service started well but once the fault was found and

The alignment kit is well made but the instructions are not enough. The support phone is useless. The person on the other end of the line spoke in broken English and asked me if I had asked my question through the website first? No, I didn't ask my question through the website initially because I'm in the middle of work and wanted to talk to someone! The instructions don't mention that you need a spring compressor to relieve the pressure on the top of the spring mount so you can rotate the…

By far the best way to raise the front of your truck with little to no effort, limiting your truck's practicality or requiring many parts to be swapped out and is very convenient. cost efficient. Rides like the original and only needs readjustment to get you back on the road. I only use 33" tires on my truck, but my 2006 F-150 fits 35" tires with no friction. I think my 2013 is no different in that it can match tire diameters. Opinion that the nose sticks out a bit if you ONLY install it. This…

It seems to be a decent level. It was installed within 2 months. Pros: Good quality All hardware included Installation wasn't terrible. Had a few issues (explain later) Finish seems permanent Cons: Installation was deeper than I was hoping for. Had to rotate the strut 180 to reinstall unfortunately had to. It's not hard to do, but it just takes more time. This kit has a 2.5 inch level which is actually more than you need. It was 1 inch too much for me and now I'm squatting on my truck for a…