🚪 Pair of Rear Liftgate Hatch Lift Supports Struts Shocks 6102 for 1999-2003 Lexus RX300 Review

When I ordered these I thought I might have some problems based on the experiences others have written in these reviews but I have had absolutely NO problems with these supports, they worked great and followed the instructions as written, I was able to remove the old ones and install the new ones in less than 15 minutes total time, no drilling nothing, just perfect for my wife's second city car, a 2000 Lexus RX300. . She also has a 2017 Toyota Highlander that she is looking to reduce the…

Update - October 21st. Well, in addition to my original comment below, just a few days after installing one of the shocks started popping out of the ball mount. Happened twice in one day so looks like I have a problem with that shock. We write to the supplier, we will look at his answer. I will update. Original Post I got these after not being able to find them anywhere near where I live and struggling to keep a rare lid open with a broom for 6 months (no fun and embarrassing). It happened very

I ordered a slightly cheaper pair from another site but it didn't fit me. I saw reviews of another product on Revain but was put off by reviewers saying they had to drill one of the holes to fit. So I decided to give them a try even though they didn't have any reviews. You are powerful; I wouldn't want them any stronger. Installation was fairly easy: the hatch was propped up with a paint pencil extender and an impact wrench was used. But a 1/4" ratchet and an extension should work just fine. I…

I don't like to just throw out bad product reviews, but in this case I'll make an exception. After unpacking the two racks, I attempted to test the strength of the piston. This was before the existing shelving was dismantled. Basically I wanted to see how much pressure it takes to close the piston. What I found was that even with my full body weight (180 pounds) pressing on the bar, it didn't move even a fraction of an inch. To make matters worse, the second rack had the same problem. It was as