🛢️ Moeller Marine Products: Fuel Tank Sending Units for 4 to 28 Inch Tanks Review

Assembling, measuring and cutting is easy with wire cutters. Now for the important points. Look at your gas tank and line up the lever that goes up when the tank is full. Easy adjustment and rotation by loosening the center screw, twisting and retightening. Important, before you align the lever, make sure you align the five screws the way you want the module to sit. Then make sure to align the five screws on the rubber washer as follows: 3 at the top and 2 at the bottom. Thread all five bolts…

works perfectly, installation can be tedious, depth of tank measured (mine 16", mark 8 1/2 down) (according to instructions) and float screwed in, "cut everything". " the residual shaft (instructions say to leave 1/2" of the mounting shaft to avoid emptying my installation tank) Loosen the nut on the round plate (the plate rotates), pre-install the float and straighten the Holes out as needed (ground strap aft) (float on 2 hrs on my tank) checked bolts alignment, took off, put gasket on, bolts…

These gauges have a good full/empty response when used with a good gauge. But there are problems with the instructions. First, it's 1/4" from the bottom of the bracket. Just mount it flush with the end of the bracket. If you leave that 1/4" overhang, you can't get it into the 1-1/2". -Fit hole in tank also moving down only helps for correct half reading (half depth + 1/2" bracket cut guide is correct). The lid only closes in one position and the instructions say the mount can be rotated every…