Optimized Printers for Monoprice Surface Replacement Review

I placed this on a sheet of glass and then used clamps to press the glass against the heated surface and it worked great. Much better adhesion as the Monoprice Maker Select Mini V1 has nothing on the bed.

My Monoprice Mini had theoretically the same build footprint. This went on for about a week before little tears and tears appeared on it. This particular build surface works great and has survived over a month of use without a single wave or crack. The biggest problem on the back was removing the adhesive from the aluminum build plate. The best advice I can give is to get some Googone and be patient. However, if something happens to my worktop, I would happily buy this product again.

I am writing this review to let you know what I think is the best way to replace a previous mat on your mini printer of choice. The footage I received appears to be identical to the original footage. To replace, first use a razor blade and pass it under the existing sticker on the build plate. The plastic peels off, leaving a thick layer of adhesive. Then preheat the workbench to 60°C. This will help soften the glue. Once hot, use a razor to scrape off the glue. Hold the razor low, like you're…