Superior Performance Unleashed: Moog 369 Universal Joint - The Ultimate Drivetrain Solution Review

The front joint in Durango 5.7, this part was easy to put on the shaft but at first it was difficult to remove the shaft from the truck.

I give 5 stars because it's an $8 Moog Ujoint made in the USA. The only problem is that it doesn't fit my 87 3/4 ton Chevrolet However it seems to fit on a smaller axle. I'll throw it on the shelf for another project

I used this to replace the universal joints on my rear driveshaft. No vibration. I prefer to buy Non-Lube. Just because it's one more thing I need to keep up with.

Good product. Just make sure you lubricate the bearings very often after installation. Otherwise it eats the heat. I drive through this place on my custom built 4 wheeler.

Purchased specifically as shown, made in USA. The reviewed product was not marked as advertised. Still 3 stars up for grabs as Mug is a trusted name. The quality seemed a little off as the casting was not machined square. The product fits well and it is only for the front driveshaft. I would return it for the back.

I prefer Moog to other brands of gearing products. This is for my Jeep and I'm often on the track where durability is a big deal (it could be a long walk if an accident happens). They were ok but one of the two sent in was defective (the tread was not polished enough) so I had to return it. As usual, Revain processed the return and I received a refund, but I think I'll just stick with Moog.