Mopar 68235275AB Fuel Filter: Superior Filtering Efficiency for Enhanced Fuel Performance Review

Just installed this Mopar diesel fuel filter on my 2016 Ram EcoDiesel ($32.10). This newer design is a major improvement over the previous OEM filter which may have been installed incorrectly and resulted in seal failure. The new one (Mopar 68235275AA) has a protective nylon sleeve around the filter to prevent bubbling and also has nylon guides to ensure the cartridge snaps into the housing and rotates perfectly on the threaded base. I used the "click in the case first" installation method…

Attention! The newly unpacked seal was defective. I checked the gasket before installing it in the case. Mounted the cap on my truck and only ran the system to spray diesel fuel over my garage. Fuel flowed from 2 different points to the end of the case with a gasket. I removed the gasket from the case and checked again. Thinking it was operator error or maybe I had twisted the threads on the case, I took the case off again and examined it again. No problem with the naked eye. I refueled and…

UPDATE 1/3/2020 THESE FILTERS ARE NOT OEM FILTERS. CHINESE FAKE, YOU WILL TAKE YOUR FUEL SYSTEM, NOT BUY! The box says they are made in Korea but the filter says they are made in China. Filter racks break off, which can enter the fuel line and cause catastrophic engine damage. Revain must remove this seller immediately. The OEM fuel filter works great for my Ram 1500 Ecodiesel. I've had it for about 2 months now and haven't had any problems. It was pretty easy to install. Simply unscrew the old

Buy a special key for the 2017 Ram 1500 Ecodiesel. Then locate the filter above the drive shaft in front of the spare tire. Using a wrench, unscrew the filter cap about 3 turns or until you decide to finish it by hand. Then remove the wrench and take a 1 gallon ziplock bag. Then cover the filter assembly with the bag and unscrew by hand while holding the bag over the filter. Eventually it will weaken so that the fuel falls into the bag. About 1 liter falls into the bag. Once the cap is fully…

Using an adjustable oil filter wrench, loosen the filter cover so that it can be turned slightly by hand. Then place a 1 gallon freezer bag over the filter and unscrew the cap. A few ounces of fuel and a filter cap dropped into the bag. Then, install the new O-ring that came with the filter, snap the new filter into the filter cap, and hand tighten onto the filter module. Tightened with an oil filter wrench as the specs are 19 ft-lbs - take it easy. Fill the module with fuel by turning on the…

This is a new upgraded fuel filter for 14-18 (maybe 19) Ram EcoDiesel models. It may also be suitable for other applications (but certainly not for the pre-18 Jeep EcoDiesel). I use it on my 16 Ram EcoDiesel. original (see below). Compared to the original design, it is said to better withstand pressure pinching and leakage around the mechanical seals. However, you must take the same precautions as the original filter: do not place the new filter in the shell - gently slide the filter onto the…