🚙 Mrhardware A01 Kayak Roof Rack: Ultimate SUV Car Top Mount Carrier J Cross Bar for Canoe and Boat - 1 Pair Review

Good rack for the price. Together they work well, beautifully and reliably, they do their job. The shoulder straps that come with it are also okay. I especially like the bow and stern straps. As far as putting it together, it was a royal pain in the neck. Took forever. The tool they give you doesn't really work, had to go to my dad's house and use a socket wrench which made the job a lot easier. The directions were almost useless. A tip: make sure the screw is fully inserted into the holes…

This unit replaces a previously purchased pair kit that broke. This unit has 2 clips and the other has 1. However the screws are short and if you have a thick stand like Thule it won't fit. The rear propellers go through 2 tubes and are positioned higher, reducing the propeller length. I had to get 4 metric spares from the hardware store that were 1.25mm thick. The photo shows the screws were branded at $2 each. Added $8 to the total price and all 8 had to be replaced but the store ran out of…

Used the product description to make sure they fit my car. While measurements showed they would fit, they didn't quite fit. Installation was difficult. With the help of tools (not included in the kit) and a lot of time, we were able to assemble them and use them for our kayaks. The first ride went well, no problems. The second time, a large piece of styrofoam on one frame was worn away. The other scratched the roof of the car even after tightening it many times NOT to loosen or damage the car…

The product description says that the item is assembled and you only have to assemble it on your vehicle. See below. EASY ASSEMBLY: Assembled by the manufacturer, you will not receive individual parts, but a perfect finish. Protect your car pole, won't scratch it. Fits most factory or aftermarket square and flat bars (OEM bars must be within 2.5" width and 1" thickness). I tried to assemble all the parts myself but they don't fit. The problem is nuts and bolts. They don't fit in the square…

Of the dozens of unnamed inexpensive kayak mounts, this one is worth picking because it attaches to the roof rack with TWO mounts and distributes the load evenly. All the others I see on the Amazon mount with ONE center mount that is about two inches wide are held in place by a screw at each end and do not inspire confidence. I really appreciate this detail and sellers should list this feature at the top and middle of the listing. This cradle also uses the exact same struts (identical as far as