Header banner
Revain logoHome Page
πŸ”’ 4 pack of recessed d-ring tiedowns with backing plate - 6,000 lb. capacity logo

πŸ”’ 4 Pack of Recessed D-Ring Tiedowns with Backing Plate - 6,000 lb. Capacity Review

3

Β·

Excellent

Revainrating 5 out of 5Β Β 
RatingΒ 
5.0
πŸš› Truck Bed & Tailgate Accessories, πŸš— Exterior Car Accessories

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”’ 4 Pack of Recessed D-Ring Tiedowns with Backing Plate - 6,000 lb. Capacity
img 2 attached to πŸ”’ 4 Pack of Recessed D-Ring Tiedowns with Backing Plate - 6,000 lb. Capacity
img 3 attached to πŸ”’ 4 Pack of Recessed D-Ring Tiedowns with Backing Plate - 6,000 lb. Capacity
img 4 attached to πŸ”’ 4 Pack of Recessed D-Ring Tiedowns with Backing Plate - 6,000 lb. Capacity

Details

Size4 Pack
MaterialZinc
BrandMackie Ent Inc
Number of Pieces4

Description of πŸ”’ 4 Pack of Recessed D-Ring Tiedowns with Backing Plate - 6,000 lb. Capacity

4 sets of D-rings and backing plates. Both components are zinc coated to inhibit corrosion. Each D-ring has a 6,000 lb straight pull capacity. For Rated Capacity Description - see below. Instructions included. D-ring SPECIFICATIONS: See diagram in the photo gallery. BACKING PLATE is used for support under the floor preventing the bolts from pulling through. INSTALLATION - these D-rings require routing, or cutting a hole in the floor. More details below.

Reviews

Global ratings 3
  • 5
    3
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Recessed D-Mounts with Plates

Excellent D-rings in our 8.5x16 closed trailer. I bought the exact same D-rings from a trailer dealer that didn't come with floor plates and cost more than them. So I found these on Revain and please take a look at the included plates required for the Β£6000 mount. There are no screws in the kit, which will be known upon purchase, so this is no reason to downgrade the product's rating. I went to HD and bought 3/8" x 1 1/2" L-bolts, flat and lock washers and nuts. Motorcycle tires roll over it…

Pros
  • External Accessories
Cons
  • The list goes on.

Revainrating 5 out of 5

Deep D-Ring Motorcycle Mount w/ Backing Plate 6pcs

I have replaced six rusty ones that only had large washers on the underside. Rings received as promised. They required a slightly larger hole in my trailer floor than the original ones, so I used a wood rasp to make the hole a little bigger. It's not the D-ring's fault, which only added a few minutes to the install. The lining is excellent. Very, very strong. There are several existing bolts in the bottom of my trailer that I had to crawl under and put on a sign where they are. Then I drilled a

Pros
  • Body & Tailgate Accessories
Cons
  • Slightly Cracked

Revainrating 5 out of 5

They are impressively strong and very good at falling out of the way

They are impressively strong and very good at falling out of the way. I have an 8' x 5' trailer with plywood decking that they were mounted on and the hardest part was finding stainless steel studs etc and a decent sized hole saw that didn't break the bank. In the end I used the base plate as a template, marked the deck and used a saber saw. The base plate was also great for drilling screw holes! Just make sure where you plan to place these anchors doesn't collide with the spacers or wires…

Pros
  • Ties and Anchors
Cons
  • There are problems