🔧 SeaSense Universal Roller Brackets (Pair) - Left and Right Mounting for Easy Assembly Review

Four issues with SeaSense mounts as shown in the pictures alongside the Smith mount: 1) Narrow base - not even wide enough to fit a 1/2 inch washer . 2) Thin steel - less than 1/8 inch Smith clamp as measured with my caliper. 3) No crimping to reinforce the bracket at the bend. 4) Not as shown on the Revain page. I sent them back.

It was exactly what I expected. Still pretty rough so if I was expecting to get them out and bang on the trailer I'd be disappointed. I intended to paint them so I sanded them and painted into the finished product. There were some rough edges and ridges that needed to be knocked down. Exactly what I wanted but could have been worn and done right away if makeup hadn't been a factor.

The quality of the metal is generally decent, with no sharp burrs and well rounded. Although it is very difficult to attach it to a boat with a bracket removed. Also if the bolt and roller are inserted from above to try to connect the brackets. This still makes mounting the bracket difficult. Next time we'll use a solid splint instead of a split one.

These brackets are more than capable of supporting the keel roller - no problem here. I have a problem with looks. By far the worst job I've ever seen electroplating a piece of metal! OMG, runs, blobs and big splotches. I have no idea how someone could do such a bad job. I ended up just sanding them down and then painting them to match my caravan. I probably should have sent them back but it would have cost me almost the same and there is no guarantee the new set will be any better. I would…