Header banner
Revain logoHome Page
πŸ–¨οΈ creality printers silicone adhesive - 310x310mmx1.5mm logo

πŸ–¨οΈ Creality Printers Silicone Adhesive - 310x310mmx1.5mm Review

3

Β·

Excellent

Revainrating 5 out of 5Β Β 
RatingΒ 
5.0
πŸ–¨οΈ 3D Printer Parts & Accessories, 🏭 Additive Manufacturing Products

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ–¨οΈ Creality Printers Silicone Adhesive - 310x310mmx1.5mm
img 2 attached to πŸ–¨οΈ Creality Printers Silicone Adhesive - 310x310mmx1.5mm
img 3 attached to πŸ–¨οΈ Creality Printers Silicone Adhesive - 310x310mmx1.5mm
img 4 attached to πŸ–¨οΈ Creality Printers Silicone Adhesive - 310x310mmx1.5mm

Description of πŸ–¨οΈ Creality Printers Silicone Adhesive - 310x310mmx1.5mm

120V silicone heater for Creality CR-10 /CR-10S 3D printer build plate heating. 商品特性.

Reviews

Global ratings 3
  • 5
    3
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

A must for PETG and ABS printing

Added this to my CR-10 heated stage and wow. easily one of the best improvements I've made so far. The bed heats up in seconds, not minutes, hours or unfortunately never. I can now print PETG (Bed Temp 85Β°C) and ABS (Bed Temp 110Β°C) with no problems, however this would require the hotend to be on an All Metal rig (MicroSwiss has a great option that I use). Note: In addition to this heating pad, you will need a solid state relay and an insulating sheet. so that it is convenient to "get your…

Pros
  • Lots of positive vibes
Cons
  • No productivity

Revainrating 5 out of 5

Check settings

This is a big improvement over the 12 volt bed I had. I like the increase in performance. I had a problem to solve and I'll share it here in case anyone else comes across it. After installation I noticed that my prints had horizontal lines every few layers and the pages were generally very rough. I also installed a new control board when I switched to this bed heater, so I spent a lot of time thinking that my print settings were somehow messed up before realizing what was going on. The PID…

Pros
  • Excellent overall performance
Cons
  • Doubtful

Revainrating 5 out of 5

Great upgrade for CR-10 - ASA and ABS printing now handy

** Please note that you will need soldering equipment and basic electrical skills for this upgrade, as well as a solid state relay (required) and an insulating pad (recommended) ** I wanted it to be I could with Filament ASA for small technical parts, but the standard platform on my Creality CR-10 didn't get hot enough. I found a YouTube video (search "cr-10s heated bed upgrade") with detailed instructions and decided to give it a try. Although my career spans 35 years of electronics design…

Pros
  • Absolutely amazing!
Cons
  • Not bad, but...