ESUPPORT Car 12V 20A Momentary Light Button Rocker Toggle Switch with Blue LED: Winch in Out ON-OFF-ON 7Pin Review

No directions but I figured it out. I have used this for the left and right steering on my Rangers articulated snow plow and it works perfectly.

High quality switches I love them. It took me a while to figure out the wiring, but the one switch I got worked as expected. You should send it with a chart

Good momentary switch to start the winch, no instructions but plenty on the net. The lights are very good, a small one hangs on the contacts of the bottom switch, a large one on the contacts of the top switch.

This switch was just what I needed as my winch's on switch kept getting stuck while painting. This one looks a lot better too. I also installed such a switch for my lightbar. My UTV's dash looks fine now.

This switch works well with my winch. Easy installation and looks great. Wanted a switch that matches the factory blue LEDs in my Terix. I liked this one so much that I ordered five more switches for different purposes. Considering the quality, looks and price, you can't go wrong.

I used this to replace the switch that came with my Harbor Freight (Badland) 5000 lb winch. Installed in the crew of a 2014 Polaris Ranger 800. I installed it to the left of the steering wheel so I can stand out of the car and look at the winch cable as it comes in to avoid pulling it over the fairlead (I think that's called a cable/hook). One of the pictures has instructions on how to replace the 3-wire switch that came with the winch with this 7-pin snap-action switch.

It took me a little while to figure out how to connect it to the reverse polarity but once I figured it out it did worked perfectly (needed to bounce to the ground. The only reason I didn't get 5 stars is that the moving part of the switch is quite long and not ideal for my setup, so it doesn't bounce back.Update: After very little use the switch is intermittent it is also difficult to connect the wire so that it is lit all the time, to do this run hot and ground the top 2 pins and swap the hot