TIANSE Red PLA 3D Printer Filament: Enhance Your Prints with Brilliant Reds Review

This stuff is intense. This is probably the most intensely pigmented filament I've ever had, which says a lot. If you like red, this thread is for you. It does not spread or turn orange when exposed to the hot side. It's a gloss/glossy/non-matte type of PLA that people often complain about sticking issues with the printer etc. It sticks well if you have a flatbed. and good general adhesion (I use Elmer's spray adhesive on PEI film) but I wouldn't count on it sticking to bare glass or anything…

Update: contacted support again. They blame the end users when the machines overlap the thread and the bobbin gets stuck. You really have to try hard to figure it out. The customer service is worse than the product. Update: I emailed the seller, left this review and messaged directly. Got a response to my review after doing all these things to contact the seller for a solution (already had and was still waiting most of the week for them to actually reply, could have responded to my review to…

UPDATE 2018-05-06 Now that my machine is properly calibrated and I've done a few prints with this filament (205C worked fine) I'm glad I did My initial problems were with my hardware, not the filament. The thread is just thin. However, note that even though the box says Tianse, my reel says "TacTink" and not Tianse. I don't know if one of them is a rebrand of the other or something, but it was worth mentioning. --- UPDATE: April 29, 2018 The Z plane and this red thread was put on a slightly…