🔒 Tigeracing Tie Down Anchors for 1988-2013 Silverado & Sierra 1500 2500, 1988-1998 Silverado 3500 & Sierra 3500 - All Metal 3000 LBS Capacity (Set of 4), Retractable Truck Bed Top Side D Ring Compatible Review

This is a solid but fiddly fitment, fits very tightly on my 1998 Chevey and I have to use a screwdriver under the brackets to pry it up. The best I've seen.

Doesn't fit my short bed 98 Silverado 1500. I thought I made a mistake when ordering but according to the listing it fits. Then I realized it wasn't the fittings.

These anchors seem really well made. Installation was pretty easy. I've used them a few times with ratchet straps and am sure they will hold things in place with no issues. They clean up great.

This is really great quality, the best yet. I've had a few claiming that, but this brand still holds the cake. All metal, including the top flange, won't fade in the sun like plastic that cracks over time. Everything I've seen so far has been stainless steel. Use a PH3 screwdriver to install. I used some screw lock to be on the safe side.

These will not fit the 1994 Chevy K1500 Fleetside. The bed pockets are 1.430 wide and the drawstring is 1.470". After 15 minutes of hemming (aluminum alloy is tough) I managed to fit it in the bag but the steel plate securing it is too wide and you need to lengthen it the screw holes. A lot works for 4 stake pockets. They are very well made and very well finished. Too bad they are made .040" too wide. My money was refunded 100%. Thanks!

The product was installed on a 2012 Chevy Silverado 1500. The brackets are made entirely of metal and have a good build quality. They are easy to install if you remove (not just loosen) 2 screws before installing. The problem I had was that 2 of the 4 zippers were not tightened and fit loosely in the stake pockets. I made spacers out of old truck hose to fit between the zip ties and the pickup box, which solved the problem.

Took 3.5 hours to install as the part that fits in the pannier bag is 1/16" to 1/8" too big. After using a diamond hole saw to grind the caps to fit the post hole, I had to use a block of wood to make sure all the metal edges were vertically aligned. After all that, a wooden block still had to be used to push the product flush into the pocket. Send a smaller set for seller credit. However, they should not be sold as fitting this model if they have a better fit. Otherwise the quality seems…