🔗 Set of 2 Trunk Cargo Hooks Compatible with Honda Accord 2008-2021, Civic 2010-2021, Acura TSX 2009-2014, ILX 2013-2021, TLX 2015-2021 Review

Installed it on a 2019 Honda Accord Sport first. Cannot test on other models. Seems to be of good quality, was a bit disappointed when I first read the instructions as other reviewers mentioned you would need a 6mm rivet nut tool to install per the instructions. Then I realized that there was a nut in the mounting pocket that could be used in place of the rivet nut. It's a little harder to get with a wrench, but it can be done with a 10mm open end without too much trouble.

I bought these for a 2021 Honda Accord. My previous car was an Audi A4: it had folding hooks that did the same thing. I missed her in the deal. They come with all the necessary hardware, but are a bit fiddly to install. The instructions are terrible and unhelpful. You need to find the correct mounting holes that are pre-drilled in the Accord and then use some skill to hold the screw in place to secure it. If you are good at these things you will find out and get it in less than 15 minutes. They

When you review a product, learn how to write correctly first. There is no speculative tool or river tool. Shame on those who post reviews without even taking 10 seconds to check the spelling. However, these hooks are great. You do NOT need to buy a special riveting tool, a hex nut is included that can be used to fasten the screw, eliminating the need for a riveting tool. This fact isn't made clear in the instructions, but if you've ever assembled anything with nuts and bolts, you'll find out…

I didn't hit 3 pounds of torque and one already snapped. It's holding up, but the crack makes it look awful for anyone to see. No, you do not need a riveting tool. You have two options for installing the mount: use the large washer and thread it over the hole by hand if you have little fingers, or use a 10mm wrench to remove the washer and 10mm wrench hold in place and use 10mm. a millimeter wrench to fix it by tightening it with a 10mm socket, while the weight hook is in a 10mm wrench into…

Installation requires some time, skill and special tools (insertion tool with nuts - 6M (6mm)). The dealer can do this in an hour's work, but if you have the tool and know how to use it, the entire project takes under an hour. If you are familiar with car upholstery and know exactly what you need, maybe 20 minutes. But buy and install two, not one; You can always add the second later, but you have to remove the first to install the second and then reinstall the first. The newer hooks are better

So there are a number of reviews that express dissatisfaction with the fact that a riveting tool is required for assembly. Please look at the spot in the trunk where the hooks are attached and think about it. When I got the hooks and looked at my car, I ran to the hardware store with one of the hooks and assembled my own mounting hardware for about $5. I didn't want to mess around with the rivet tool. Plus, with a few bolts, washers, and a couple of nuts, you can take apart and reassemble parts