🔧 UREMCO Fuel Injector Seal Kit - Enhanced SEO, 1 Pack Review

I was able to replace the earrings in the injector with the old wire, connect to the battery, open the injector, clean and blow air, then put new parts in and saved $47. up to $75 each

O-rings fit, the bottom O-ring retainer is what I needed and it snapped in and works great. I don't know how to replace the fuel screen so I didn't. .

These are great value if you can install them correctly. The fuel injectors for my car were very expensive so replacing the basket and o-ring was a big saving.

Gaskets are tight (as they should be), but they tend to be so tight that they snap when you try to insert them. 2 out of 6 cracked and I had to replace them with what was left of the old setup. Not good. Stronger material OR additional spacers must be provided.

I have contacted UREMCO because of the large size difference between the OEM Pintel Cap and the one supplied. The one included in the kit is small enough to get into the cylinder cavity through a hole in the intake manifold. Not only does the OEM keep the o-ring in place, but its larger diameter butts against the bottom of the intake manifold injector port, keeping all injectors at the same depth in the intake manifold. If you install the included Pintel cover, it barely covers the inside of…