Vepagoo Compatible 2003 2008 Liftgate Supports Review

My trunk/hatch on my 2006 350Z (no spoiler) would sometimes raise and sometimes not. Only changed on the driver's side, now it works perfectly. No more sticks in the trunk in case he doesn't want to get up. Easy installation, took about 15 minutes. The factory seems to fit. A+++Have another one in case there are any problems in the future

I've had them for about a month now and they're still holding up. I have a pretty heavy spoiler on my sunroof and those struts don't seem to move at all. Installation is very easy, there are even instructions, so I'd say you'll be done within an hour. Just as a note, if you have tongs you can place them on one side of the rack to hold it while you work on the other side.

I don't have a boot spoiler or anything extra on the tailgate but they are very solid. If I had a spoiler, it wouldn't bother me at all. Very easy to install. Using a small flathead screwdriver, gently pry up the retaining clip on the ends of the shock absorbers to seat the ball joint and loosen. Comes with new pivot points, just screw them down 10mm. Easy. You want this for your 350Z.

Here they are! Instructions are in the comment above, BUT: ** You should put a rag or something similar under the underside of the brackets so the metal doesn't scratch the paintwork when loosening the screws as there may still be some pressure in them. Also, be sure to remove the lower mounts first, as when the struts are under pressure it will be difficult if not impossible to detach the upper 12mm mount.**

It was a great price. Everything fit perfectly on my 2004 350z. I installed it a few months ago and am impressed with how well it works - I've had no problems. Took me about 30 minutes to install with the help of another person. The trunk is very heavy so we used a support bar and had a second person to hold and push and pull when needed. All in all it was a very easy install and I am very happy with it.

They were very easy to install. I've put it off for a few years, but I'm finally tired of this falling on my head. If you're nervous about doing it yourself, don't do it. The company obviously knows what it's doing. Just make sure you follow the instructions NOT to install the underside upside down as this will result in the top of your hatchback sticking out - just like another less detailed reviewer's picture shows in another review.

The shock absorbers were easy to install, but the end of one of the shock absorbers was wrong so it didn't fit the car properly. Contacted their support team and they were able to get a new set of shock absorbers very quickly. If both are installed, the barrel at the lower end of the rack is noticeably heavier. They also require more time and strength to lift than storage racks. However, they are very strong and can support the weight of the barrel at lower angles. Overall I have full…

These gas shock absorbers for the 2007 Nissan 350Z were very easy to install. For comparison. He doesn't move or flap his fingers! Replace one side at a time.3. Remove the (2) 10mm screws from one side of the car mount with a 10mm head and once loose move them into the rear hole to avoid damaging the car's exterior! 4. Use a 12mm wrench to remove the ball joint from the tailgate assembly and carefully remove it from the vehicle. Don't scratch your car! 5. Wipe down the car mount holes and…