🔌 Boss Snow Plow Wiring Harness Repair Kit - MSC04753 & MSC04754: Restore and Optimize Your Snowplow Blade's Electrical System! Review

Worked great, the only drawback was that a couple of the barrel connectors were not crimped at the factory and had to be redone.

I would not buy again or recommend it to anyone. Installation was very easy, just compress 16 joints and you're done. But the plastic is very hard, so you can't even fully connect the two ends together. So the installation does a lot of good. Now I will order through a local dealer. Lesson learned.

Replaced the main wiring harness from the Boss truck and snow blower, both ends. On a 2004 Boss snow thrower. Like new. Almost every time I encountered a pile of snow, there was a problem. I had to fully squeeze and wiggle/twist the ends of the straps to get the plow to work. No longer. New seat belt ends solved my problem.

These are not Boss factory wire ends. This is an aftermarket for SAM production. It's a subsidiary of the buyers (they make snow plows). The product description is a little misleading as they use Boss part numbers and not the SAM part numbers they send you. Personally, I knew I would have found the real ends of the Boss wiring when ordering. They seem to be of good quality, but I usually prefer to order OEM parts.

Was glad to find this while browsing Revain as I had never seen them in a sales advert before. It's amazingly easy to remove and replace the old connectors at a fraction of the cost of a new wiring harness and a fraction of the frustration of replacing the entire wiring harness. It took me less than an hour to install it on my dump truck and the pre-wired connectors were an amazing addition. I have already recommended this kit to 4 of my friends who have plows and will recommend it to others…