Header banner
Revain logoHome Page
🔧 wyzworks petg 1: high-quality additive manufacturing products for petg filaments logo

🔧 WYZworks PETG 1: High-Quality Additive Manufacturing Products for PETG Filaments Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(1)
img 1 attached to 🔧 WYZworks PETG 1: High-Quality Additive Manufacturing Products for PETG Filaments

Description of 🔧 WYZworks PETG 1: High-Quality Additive Manufacturing Products for PETG Filaments

PETG is extremely durable and tough, all while be odourless. Very low shrinkage and warping, ideal for large prints. Less brittle than other material types with great chemical resistance. 1KG (approximately 2.2 lbs) Spool of PETG (Polyethylene Terephthalate Glycol-Modified) 1.75mm Filament Diameter (Dimensional Accuracy +/- 0.05mm) 1 KG (2.20 lbs) Comes Vacuumed Sealed. Recommended Printing Temperature Range 210°C - 250°C. Customer Support - Get the absolute best filament & support at half the cost of main brand filaments. If you aren't happy with the product or have any issues, don't hesitate to contact us. Save money without risking your equipment, print quality, & time!. Compatible for most common 3D printers such as ROBO 3D, Cubify, Leapfrog, MakerBot, Reprap, Afinia, UP, Mendel, flashforge, Solidoodle 2, Printrbot LC, MakerGear M2, Felix, Reprap, Ultimaker and any other 3D printers.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

This translucent purple PETG looks amazing right out of the box

This translucent purple PETG looks really amazing right out of the box. The color is even and the translucent PETG has a beautiful crystalline sheen that complements the purple color very well. I print at 240°C heated to 70°C.

Pros
  • The best in its niche
Cons
  • I'll add later

Revainrating 4 out of 5

Doesn't fit Prusa MK3

Yarn seems fine, but the hole in the spool is too small to fit the Prusa Mk3S spool holder. You can get it working by removing one of the levers from the spool holder, putting the spool on it and reassembling it. Edit: After reading another review I found that you can remove the center of the spool to make the hole bigger. .

Pros
  • Best
Cons
  • Ugly packaging

Revainrating 2 out of 5

Poor quality control

The packaging was found and the filament was not vacuum sealed which is very important as it will absorb water and ruin the filament if you don't know how to dry it. It was in a bag but it looked like a balloon, it's not that hard to dry but I'd rather do it because I left it, not because I bought it and I need it. Will definitely not buy again.

Pros
  • Decent performance
Cons
  • Miscellaneous Miscellaneous