🖨️ Replacement Accessories for CHPOWER Extruder 3D Printers Review

I had a nasty filament block on my factory hot end and after cleaning it I could never get it to print, it was always under extrusion . So I sat down to buy parts to replace it and soon found that replacing the whole thing would be easier. The bowden tube is a nice length and can be used with the s5 but can easily be cut to normal length. 300mm version. After cutting the tubing to size (14") I began removing the factory plugged hot end from the printer and before I knew everything was replaced…

The standard hotend on my CR-10 kept failing, component after component. First a fan, then another, then the extruder was constantly clogged. I ended up getting tired of messing around with it and just replaced the entire hotend. These include updates to the hot end with a silicone sleeve on the heater block instead of the standard band and thermal blanket. My CR-10 prints like new with this new hotend and installation was quick and easy. Screw the extruder assembly and fan shroud onto the…

I bought this new head because I had disassembled my other one to set it up and after printing with it for a while I decided to go back to stock to start over as it will be my first foray into 3D Poetry was so I didn't really know what I was doing. For spring cleaning I disassembled and reassembled my printer (CR10S), aligned, cleaned and tightened everything. I installed a new hot end build and it worked fine for a few prints and I've started noticing burn marks on my products. So I started…