Enhanced DEEPCOOL GAMMAXX400 CPU Air Cooler | 4 Heatpipes, 120mm PWM Fan, Blue LED | Intel & AMD CPU Compatible (AM4 Support) Review

After installation, I ran into the RAM and replaced the fan with 2 thin ones (I found the brackets on the alik). If there is no thin fan, then in principle you can raise the native fan. On my motherboard, the cooler also blocked the space for a high ssd (m2) radiator. In the first photo, a comparison with 200.

This is already the third deep cool cooler in the family - two others of the 200th series. For AMD 5600X, it was decided to take a larger unit. The installation is well described in the instructions. But there are some points that I would like to draw attention to. The 200th cooler in the case of AMD is attached to standard mounts, and for Intel, an AMD-type frame is placed there and a cooler clings to it. Here, the cooler must be screwed to the plate on the back of the board and hold this…

I bought it for 1,913 at one time for an AMD Razen 5 3600 processor. It has been serving for about 3 months. The temperature of a processor in a ventilated case (XPG Valor Air, in which there are 3 fans for intake and 2 fans for exhaust) does not rise above 70°C. In general, a solid cooler for mid-budget and not hot processors. By the way, on AMD processors, the temperature can jump sharply. This is due to their factory turbo boost. Therefore, if temperature fluctuations bother you, undervolt…

When I initially saw this cooler, I intended to take the first version of it, but when I noticed that it was fastened with clips, I started seeking for another one right away. And, lo and behold, the second iteration of this dashing chap has been released, which has brought a huge smile to my face. Thank you OnlineTrade. Ru

There wasn't much "sediment" left despite the favorable pricing of 2100 rupees. I want a formal apology from the store, but I don't need a significant discount on the new case I wish to buy to replace the old one.

My take on this merchandise.Replaced stock cooler from amd due to noise and heat. Deepkul did his job well. Quiet, the body is cold.

In general, I am satisfied with the purchase, after reading the reviews I did not use the thermal paste that came with the kit. Pros below: The 10400 cools well for me, the average temperature in games is from 40 to 60 degrees, easy installation, the most important thing is that it is quiet. Cons below: The brackets with which the cooler is attached are somehow very tight, while you fasten it, the radiator bends.

Already during installation, I found that the complete mounts do not fit the lga 2022 v3 socket. I had to expand the mounting hole on the plates for intel. And it works quietly, cools well.

I really liked the cooler, it copes with its task by 100%. Quiet, easy to install and very powerful. Cheap and angry. Stands in a system with Asus TUF Gaming B460-Plus and Intel Core i7-10700F Pros below: 1. Value for money 2. Reliability of materials 3. Quiet, even under load it is almost inaudible, although it works at high speeds 4. Backlight that does not hurt the eyes Some cons: 1. It collects dust well, so you need to clean it at least once every 3 months

very nice nice cooler for its 1300 copes with the task very worthily, does not crack, the percentage does not overheat, the backlight is beautiful blue wonderfully mysteriously stylish hype and megashweps

Stone 5 5600x did not rise above 62 degrees. In the test from Hades, it stayed at 50. Pretty quiet, almost inaudible. Since the assembly on amd is red in the subject)

I don’t like the backlight, but it will do - it’s not visible under the table Has pros: Works great with ryzen 5 5600x 4.5*100hz. The kit included dies for 1200 and 1700 sockets. I bet on am4, on the mother of Aorus, and so there is a steel reinforcement bar at the back. Cons: There were problems with the installation, due to my curvature rather and little assembly experience.

They write that it is quiet, but I don’t agree here . It buzzes like a Boeing during takeoff. During the day, it's almost inaudible (the computer is under the table), but in the evening it's audible even in the next room. It copes with cooling, there are no special complaints about this piece of iron. Glowing. For some, this will be a plus. My body is closed, not warm, not cold.

You can use the i5-10600K under this cooler without overclocking (125 W is already an impressive figure for this cooler), but since my mother supports auto-overclocking of the processor, I see no reason to spend money on such a "stone"! Got pros: Reliable fastening on 4 screws and the back panel; a huge heatsink and a conscientious fan (i5-10600 at a frequency of 4.5 GHz and under a load of 50% gave out no more than 70 degrees); good equipment and wide coverage of various sockets. Has some…

Pros below: Powerful and cools well. Quiet at work. It makes noise for a few seconds only after turning on or restarting the computer. Inexpensive. Different cons: The installation is a little tricky. Until understood, that where, and as - perspired.

Packed perfectly, all components are in place, there are two sets of fasteners in the box, for AMD and for intel, the paste is included, I recommend to buy

I decided that in six months I would change the thermal paste along with the cooler and did not apply for a refund, so as not to delay and did not want to overpay for the manufacturer's defect. In general, there were spoons, but the sediment remained. Check carefully before installation. If they make a good discount on account of a future purchase, or exchange it (to fix their marriage, but after six months), I can reflect it in the review. And while very disappointed .

I bought this fan to cool my Ryzen 5 2600 as Wraith Stealth wasn't enough. The Wraith Stealth idled at around 40°C and under load up to 75°C (outside the limits accepted by the community). Gammax on the other hand (combined with Kryonaut coolant) idles at 26C and hits 54C under load. Installation was painful, worst I've ever had. It's not really "compatible" with AM4. It doesn't have brackets to mount on a board other than Intel, so I hope you have the adapter parts. You also have to use a…

I decided to try this cooler with my Ryzen 5 2600 build, chose the push-pull configuration with the included Deepcool fan and the optional Noctua NF-P12 fan with 1700 rpm. Replacing the original AMD cooler with this one was not easy due to the lack of space. I ended up having to remove all of the existing case fans and graphics cards to get the job done. It was definitely worth it in the end as my CPU gets a lot cooler. Since installation, the temperature has not exceeded 65°C (under extreme…

I was looking for a cheap HSF and ended up ordering Deep Cool Gammaxx 400 and Cooler Master Hyper 212 LED. Both coolers cost around $20 and are similar in size and design (4 heatpipes, direct contact). ) has a thin band of irregularly shaped metal shavings where the aluminum section wraps around the heat pipes. With a metal pick I was able to knock out some of them fairly easily, which is frankly awful for something meant to get into a computer. Back to Revain! It is difficult to say whether…