🔫 The Ultimate Torklift S9528 FastGun Derringer: Unleash Lightning-Fast Precision Review

I needed this device because the tether was jamming the gas cap and preventing easy refueling. It can be installed by changing the turnbuckle itself or in place of the turnbuckle chain. I used it the second way because I didn't want to change the turnbuckle. It does the job. With this device, my wife can refuel her truck without a wrench or other tools. She can do it herself.

If you want to mount them on Torklift Spring Loads, first buy a new good quality saw blade - the steel of Spring Load hooks is tough and high quality. . It took me about 15-20 minutes to install them, including the time it took to cut the hooks off one end of the Torklift spring loads and file the burrs. The instructions are sketchy and the pictures are awful, but luckily it's pretty easy. Once installed, adjusting the tension is easy and when in use they allow for quick take off for refueling…

Although these derringers were a nice addition to our camper, fitting them was quite a challenge. , and made one (complicated one) before discovering how their (included) Derringer camlock handle "scalloped" nuts (inside) work. It worked well in our setup. A zip tie interferes with our fuel filler flap, so I use a more modified one (which is the least "flexible" when connecting/reconnecting). The other three end in a screw eye on each end of the turnbuckle, but they work fine in the other three

I converted my Springload XL turnbuckles (which I inherited when I inherited my RV) to FastGuns with derringers and am very pleased with how much easier they work. It's a small investment (I bought locks too), but if you already have a turnbuckle system, it's a lot cheaper than buying FastGuns. on turnbuckles, which I've reworked to the point where my elbow hurt after cutting just one. Maybe I should have just used the eyebolt alternative, but luckily I have a friend in the machine shop and his

Once I assembled them following the instructions they work great and save a lot of time. However, this is to create a complete PIA. The instructions that come with it are small photocopies with horrible pictures to follow along with. If you want to use rods instead of eyebolts, it's extremely difficult and time consuming. You'll need to slide the rod through the derringer at an angle to get a wrench on the socket. You cannot just run the rod straight up and then back down as the square nut is…