🌈 Gizmo Dorks Fluorescent Filament: Optimal 3D Printing Solution Review

Supplied on a different spool than shown: black plastic. Okay, but cardboard is better. A small kinking issue, but nothing could be fixed in a minute or two. The yellow color is pleasant, I did not test it under black light. Glows a little in the dark.

Thread was not sealed so moisture content was disturbed. Printed decently after drying properly, but not really worth it when so many other brands in the same price range work great out of the box. Speaking of boxes, this thread didn't even have one. Plastic bag, padded, Winter, Michigan = probably not good to travel, sealed or not. I will say that the unproblematic prints came out fine and look very cool in the presence of blacklight.

Be sure to use glue sticks on the bed if you have trouble sticking. If you don't have glue sticks handy, just go to the store and buy 4 for $1. Buy some hairspray at the dollar store and see if it helps stick. Glue sticks seem to work for me. In any case, the PEI film is good for adhesion. I think I'm writing all this because all I can say about this filament is that it's a nice fluorescent yellow, although I ordered it because I thought it was really yellow, but I still have quite a lot…