🔥 DR Quality Parts - Premium Replacement Part: Exact Fit Dryer Gas Valve Ignition Solenoid Coil Kit 279834 Review

Inexpensive, fast shipping, easy installation, saved a lot of money compared to €300 per hour "per" (also thanks to YouTube) UPDATE: Still works. A little advice, do it yourself, if you screw it up, you've lost $7. To resolve the issue: 1. Find the model number and serial number of your device.2. Go to YouTube and find your problem by model number.3. Go to the online parts seller and find your device. A good one will have a troubleshooting section. You will also have a parts list and…

I ordered this part in October 2018 for my 9 year old Samsung dryer. The item arrived quickly and was easy to assemble. I was very glad that it saved me from having to call a repairman. Fast forward to last week, August 2019, and the play failed. After some troubleshooting, we found that the solenoid(s) were stuck. Tapping the top of the solenoid will trip it up only to get stuck again. I was very disappointed that this part only lasted 10 months. Just ordered this part, received it and…

I have a 17 year old Kenmore dryer and suddenly the first time I turned it on it started to heat up and then just blew cold air. I looked through the peephole and saw that it glowed for a few seconds, but the gas would not turn on and produce no flame (a sure sign the coils were defective). I wasn't sure if they were correct (the manual is long gone) but due to the low price I rolled the dice. It arrived very quickly thanks to Revain, so now is the time to see if it works. I gave it 5 stars for

Worked on my model Whirlpool WGD9200SQ1 Serial MW4318685 Type BADT-NAT-1206006-EL20 0.120A Part no. W10118312 According to the dehumidifier troubleshooting guide stored in the dehumidifier, the coil resistance values should be as follows: (There are two coils on the gas valve, one with 3 terminals and the other with 2 terminals.) (3 terminal coil) Terminal 1 to 2 should be 1365 be +/- 60 Terminal 1 to 3 should be 560 +/- 25 (dual coil) 4 to 5 should be 1325 +/- 55 (terminals 4 and 5 only…

coils worked as expected. Thanks to previous reviews that helped me troubleshoot. To help others move forward. The flame ignited once and then went out as the dryer heated up to a temperature (190 degrees). When it's time to turn the igniter back on, there will be a noticeable rattle, no gas will be supplied, and then the igniter will turn off. Would allow this multiple times without turning on the gas to hit the red hot igniter. The chatter led me to believe it was coils. I checked it for…

My old Amana gas dryer stopped heating air. After turning off the power, I found the circuit in the control compartment. Using a Fluke DMM, I checked the fuses, temperature sensors, wiring, heater/igniter, and gas valve coils. I found that the resistance reading on one of the coils was significantly higher than the nominal value given on the chart. Using the valve part number I found this Revain replacement coil kit. After reading the reviews I decided to order a set. Delivered next day…

On a Kenmore 80 series dryer, gas coil failure can be identified by a number of things.1. The tumble dryer runs and heats up first and then cools down but continues its cycle. Clothing may appear damp and cold when inspected after the drying cycle is complete. Your tumble dryer does not reheat during a program and requires a long cool down period before it heats up again. (If your dryer doesn't heat up at all, it's most likely not the coil).2. The dryer heats up for a short time but does not…