🛏️ AMP Research BedStep 75301-01A - Retractable Bumper Step for 1999-2006 Silverado & Sierra 1500/2500/3500, 2007 Silverado & Sierra Classic Models (Excludes Flareside) - Black Review

Don't even think about it if you're over 50, just do it. It's like a knee pad. I have a 3500 and even with the extra bumper height everything is perfect.

Pinless start for 3/4 ton truck. And because I didn't pay enough attention to 2 trips to the hardware store. I like the product, it works great, but going to the store was annoying.

Stand received today, installed in 15 minutes. Works great, it saves my old feet from wear and tear. For those wondering what the 2 extra hex screws are for, you can use long screws and spacers on 1500 series cartridges and short screws and NO spacers on 2500 and 3500 series cartridges. Made in the USA.

Expensive but works absolutely perfect. My grandfather, who is less mobile due to his age, can easily move up and down in his bunk bed. It's easy to lower it down and touch your foot and it will pop up immediately. Where it attaches was a little more difficult to set up than on my F150, but by no means difficult with a second pair of hands.

I'm in my 60's and not as flexible as I was 30 years ago. I have a hard time stepping on the bumper and pulling myself up onto the back of the truck. Even the descent can be an adventure. I was looking for some kind of ladder or step to attach to the back door when I came across this thing. The problem with mounting a folding ladder on the tailgate is that it always gets in the way. Not so with this retractable bumper step. Easy to assemble with decent instructions and weighs 300 pounds (I have

I've been wanting to buy this bed for a long time and finally pulled the trigger. This is a very high quality product that is very well designed and works flawlessly. The reason for 4 stars instead of 5 is that the bumper studs on my 2002 Silverado 2500HD weren't long enough to fit on the bed step. Luckily I have a supply of metric screws at home and it only took me a few minutes to find the right replacement screws to complete the installation. If you purchase this product, and I recommend you

Bought for friends Silverado 2000, double cab, long bed, two-wheel drive. instructions because it's a 3500. I then removed the two factory bolts from the bumper bracket on the frame and when I tried to fit the assembly it wasn't aligned properly, it wanted to go in at an angle, not flush with the seat because it was hitting the bumper? So I decided to see if the gasket would allow more clearance, which it did, but still not enough. So I got out my angle grinder and cut the bumper bracket. I put

As we got older, getting in and out of a pickup truck became more difficult. Jumping off the back door also put extra pressure on my ankles. I installed Bedstep on my 2001 Chevy truck and it works fine with the tailgate down or up. I had to buy new bolts to install it on the truck as the original bolts that came on the truck were too short. If GM hadn't ground down the last 1/2 inch of the bolts (I think they do this to make installation easier) the stock bolts would have worked. I had trouble…