🖨️ Enhancing Accuracy in 3D Printing with PRILINE Filament Printer Review

I did a little research and asked about wood PLA to print Groot as a birthday present. I tested it on a few small parts and had a lot of clogging issues. I watched a few YouTube videos and ended up using a 0.6mm nozzle instead of the 0.4mm nozzle I was using and no clogging issues. Depending on the model, there may be a lot of threads, but a large Groot sitting next to a tree trunk will have almost no threads and only a few nubs (layer height 0.3mm). I had to lower the temp to 185-190, I…

Fine wood filament with a dark, rich color. It has a wonderfully matte texture, the layer lines are almost invisible. Many people recommend printing with a 0.5mm nozzle or larger, but I had exactly 0 jams/bad prints with my 0.4mm nozzle. The trick is to print extra WIDE layer lines so the nozzle pushes out a lot of plastic. I print with a line width of 0.45 mm for the outer border and a line width of 0.6 mm for the inner border and a line width of 0.8 mm for the fill. This ensures that any…

I love this yarn. I'm making the book covers for a character in the Mistborn trilogy and wanted to make them out of wooden thread to give them a "richer" look and fit on my bookshelf. I did a bit of shopping and all the usual suspects (Colorfabb, MG, Hatchbox etc.) were sold out so I ordered a few of these and then took a picture and ordered this one. Boy am I glad I did that. I have attached a number of photos. One of the prints, two just taken out of the printer, two of them sanded, some…